BMW C1 200 Repair Manual page 191

Install clutch
•
Position spring on pin (arrow) of guide bow
•
Attach clutch at end of spring
e
Attention:
Assembly is spring-loaded - injury hazard!
•
Install retainer, BMW No. 11 7 641
•
Turn clutch (parallel lines) counter-clockwise un-
til flats are aligned
•
Allow hooks on retainer to snap into place on the
bottom of the pulley
•
Apply Loctite to threads on locknut
•
Use narrow socket, BMW No. 11 7 643, to tight-
en nut
Fluids and lubricants:
Locknut..............................................LOCTITE 243
X
Torque specification:
Nut ............................................................... 50 Nm
Vent cover...................................................... 9 Nm
Variator cover............................................... 10 Nm
Clutch drum ................................................. 60 Nm
L
Note:
Installing driven variator (
C110650
24.9).
a
21.7