Replacing The Power Socket - BMW C1 200 Repair Manual

When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
Make sure that lines and cables are correctly routed.
Avoid potential contact areas that could lead to rub-
bing and abrasion!
1
2
3
5
•
Install nuts (2) in the bottom section of the
clamp (3)
•
Position the lower (3) and upper sections (1) of
the clamp on the vehicle frame and retain with
two strips of tape
•
Install storage compartment and insert screws in
their sockets without yet tightening them
•
Install the instrument trim, using the shorter
screw at the mounting point (arrow)
•
Align storage compartment with instrument trim
•
Tighten down storage compartment mounts
e
Attention:
Make sure that the seal between front windscreen
and roof is correctly positioned!
46.26

Replacing the power socket

– Remove the instrument trim
– Remove the storage compartment
•
Pull off the rubber grommet (1)
•
Disconnect plug (2)
•
Remove socket toward the inside
When installing:
C1460900
•
Installation is the reverse of the removal proce-
dure
1
2
C1460920