Omtech SH-G1390 User Manual page 74

5 Operation
5.8.19 Locking the Control Panel
When the light blue cursor is on this item, press ENTER, and the following dialogue box will pop up:
Password Setting Sets the password for the engraver.
Locks the control panel, releasing it
Key Lock
when the correct password is entered.
5.8.20 Setting Passwords
The password settings interface is displayed below:
Every password must be six characters long.
E n t e r t h e p a s s wo r d d i r e c t l y b y p r e s s i n g
numbers or press Shift to use the keypad,
press the direction keys to select a number or
letter, press Enter to select it, and then press
Shift to return to the password selection. If
the password is entered correctly, the new
password will be saved. Otherwise, Password
Error will be displayed. Press Esc to return to
the previous menu.
67