Omtech SH-G1390 User Manual page 67

If you need to modify the parameters, press Enter and select the first parameter in the parameter
area, as shown in the following interface:
At this point, you can press ▲ or ▼ to select
a parameter and press number to modify the
numerical parameters (such as Idle Speed), For
non-numerical parameters (such as Scan Mode),
when the parameter is selected, press Enter to
enter the modification mode and press ▲ or ▼
and modify the parameters. After modification,
press Enter to exit modification mode. When the
current page parameters have been modified,
select Write and press Enter.
If you want to verify that the parameters are saved successfully, you can select Read and press
Enter. The panel will read the motherboard parameters again and display them.
When pressing or, the display switches to the parameter categories, as shown below. You can
select another parameter category to modify or press Esc to return to the menu interface.
60