Omtech SH-G1390 User Manual page 103

• Adjustment, maintenance, and repair of the electrical components of this
cutter must be done ONLY by trained and skilled professionals to avoid fires
and other malfunctions, including potential radiation exposure from damage
to the laser components. Because specialized techniques are required for
testing the electrical components of this marking system, it is recommended
such testing only be done by the manufacturer, seller, or repair service.
• Unless otherwise specified, ONLY undertake adjustment, maintenance, and
repair of the cutter when it is turned off, disconnected from its power supply,
and fully cooled. For maximum safety, wait about 3 minutes after turning the
machine off before adjusting the integrated chiller or other electronic parts.
This will allow time for the ground connection to clear any residual charge.
For common issues and solutions, visit the Troubleshooting section on our website
omtechlaser.com where real-time updates are available to assist you.
1
3
7 Troubleshooting
2
96