Omtech SH-G1390 User Manual page 11

1.4 General Safety Instructions
• ALWAYS keep a fire extinguisher, water hose, or other flame retardant system nearby
in case of accidents. Ensure that the local fire department's phone number is clearly
displayed nearby. In the case of a fire, cut electrical power before dousing the flame.
Familiarize yourself with the correct range for your extinguisher before use. Take care not
to use the extinguisher too close to the flame, as its high pressure can produce blowback.
• DO NOT operate continuously for more than 5 ½ hours. Stop for at least 30 minutes
between uses.
• DO NOT allow minors, untrained personnel, or anyone with a physical or mental impairment
that precludes their ability to follow this manual and the software manual to install, operate,
maintain, or repair this device.
• DO NOT leave this device unattended during operation. If it behaves abnormally,
immediately cut off ALL power to the machine and contact our customer service or your
dedicated repair service. ALWAYS FULLY power off the device (including using the
emergency stop switch) after each use.
• Use this laser engraving device ONLY in accordance with ALL applicable local and
national laws and regulations.
• Use this device ONLY in accordance with this instruction manual and the manual for the
engraving software included with it. ONLY allow this device to be installed, operated,
maintained, repaired, etc. by others who have also read and understood both manuals.
Ensure that this manual and the software manual are included with this device if it is ever
given or sold to a third party.
• Any untrained personnel near this device during operation MUST be informed about its
dangers and FULLY instructed on how to avoid injury during use.
4