Installing Smartdevicemonitor For Admin; Setting Up As A Print Server - Ricoh CL2000 Operating Instructions Manual

Installing SmartDeviceMonitor for Admin

Install SmartDeviceMonitor for Admin on your computer. For the installation procedure, see
stalling SmartDeviceMonitor for
After installing SmartDeviceMonitor for Admin, go to
computer as a print server, or to

Setting Up as a Print Server

Important
You must set up the print server using NDS mode in NetWare 4.x, 5/5.1, 6/6.5.
A A A A
Log on to the file server as a Supervisor or the equivalent of a Supervisor.
B B B B
Run SmartDeviceMonitor for Admin.
C C C C
On the [Group] menu, point to [Search Device], and then click [IPX/SPX] or [TCP/IP].
A list of printers appears.
Note
If you use Pure IP, click [TCP/IP].
If you cannot identify which printer to configure from the list of printers, print the configuration
page and find it. For more information about printing the configuration page, see
a Configuration
If no printer name appears in the list, match the IPX/SPX frame types between the computer and
printer. Use the [Network] dialog box of Windows to change the computer frame type. For more
information about changing equipment frame types, see
using the Control
Operating Instructions
Admin".
p.92 "Setting Up as a Remote Printer"
Page".
Panel".
Administrator Reference
p.88 "Setting Up as a Print Server"
to use it as a remote printer.
p.75 "Configuring the NetWare Protocol
88
p.98 "In-
to use this
p.134 "Printing