Controller Board - Ricoh CL2000 Operating Instructions Manual

D D D D
While holding the handle, pull
out the controller board slowly.
E E E E
Remove USB2.0 Interface Unit.
Note
❒ The removed screws will be
I
used in step
F F F F
Remove the tapes that fasten the
USB2.0 interface unit and the con-
troller board.
G G G G
Lift the end of USB2.0 Interface
Unit (A A A A ), and then remove it from
the controller board (B B B B ).
1
ZHBP020E
H H H H
Attach the Bluetooth Interface
Unit. Insert the end of the Blue-
tooth Interface Unit to the open-
ing (A A A A ), and then push down
until it clicks (B B B B ).
ZHBPB460E
2
Confirm that the Bluetooth Inter-
face Unit is firmly connected to the

controller board.

I I I I
Fasten the Bluetooth Interface
Unit on the controller board using
the screws removed in step
ZHBH960J
Bluetooth Interface Unit Type B
2
ZHBP450E
1
ZHBP190E
E E E E
.
ZHBP200E
1
32