Ieee 1394 Configuration - Ricoh CL2000 Operating Instructions Manual

Options
Connecting the cable to the
1394 Interface Unit
A A A A
1
Connect the interface cable to the
1394 interface port.
Note
❒ Either connector can be used.
❒ If you use a interface cable (6 pins
x 6 pins) connect the end with the
ferrite core to the printer.
B B B B
Connect the other end to the host
computer.
Important
❒ You cannot plug devices togeth-
er to create loops.
❒ Do not use a cable more than 4.5
meters (14.8 feet) long.
21

IEEE 1394 Configuration

Use this procedure to configure the
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
Setting Name
IP Address1394
Subnet Mask1394
IP over 1394
SCSI print
Bidi-SCSI print
ZHBP090E
Depending on the protocol you use,
procedures vary. See the following
table.
IP over 1394
SCSI print
A A A A
Press { { { { Menu} } } } .
"Menu" appears on the panel dis-
play.
B B B B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Host
Interface" menu.
Menu:
Host Interface
Value
000.000.000.000
000.000.000.000
Active
Active
Active
Steps A-H and then
go to steps M to N
Steps A-D and then
go to steps I to N
ZHBS010E