Scsi Print - Ricoh CL2000 Operating Instructions Manual

Options
E Repeat steps C C C C and D D D D to enter
the IP address.
IP Address1394:
1
192.168.000.011
Check if the pointer (k) is at the
rightmost position, and press
{ { { { Enter #} } } } to register the IP ad-
dress you selected.
IEEE 1394 Setup:
IP Address1394
H H H H
Set "Subnet Mask1394" in the
same way.
I I I I
Set "SCSI print" and "Bidi-SCSI
print" if necessary.
Note
❒ The default setting is "Active".
J J J J
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "SCSI
print".
IEEE 1394 Setup:

SCSI print

K K K K
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
SCSI print:
*Active
L L L L
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select either
"Active" or "Not Active", and then
press { { { { Enter #} } } } .
Set " Bidi-SCSI print " in the same
way.
23
M M M M
Press { { { { On Line} } } } .
"Ready" appears on the panel dis-
play.
Ready
N N N N
Print a configuration page to con-
f i r m t h e s e t ti n g s m a d e . S e e
"Printing a Configuration Page"
in the Administrator Reference.