Ricoh CL2000 Operating Instructions Manual page 161

Options
PAPER FEED UNIT Type 3000
Preparation
1
When installing multiple options,
install the Paper Feed Unit first.
Up to two Paper Feed Units can be
attached to the printer. When in-
stalling two Paper Feed Units, con-
nect the two units first by following
the procedure below before con-
necting the units to the printer.
Then, place the printer on the con-
nected two Paper Feed Units.
R CAUTION:
• When moving the machine, each
person should hold the handles
that are located on opposite
sides, and then lift the machine
slowly. Lifting it carelessly or
dropping it may cause an injury.
• When moving the Paper Feed
Unit, hold the handles that are lo-
cated on the top of the unit, and
then lift it slowly. Lifting it care-
lessly or dropping it may cause
an injury.
Note
❒ The printer weighs approximately
36 kg (79.4 lb).
❒ The Paper Feed Unit weighs ap-
proximately 8.9 kg (19.6 lb).
❒ "Tray 2" appears on the panel dis-
play when only one unit is in-
stalled. "Tray 3" appears on the
panel display for the second unit
when two units are installed.
7
A A A A
Check the contents of the package
for the following:
❖ ❖ ❖ ❖ Paper Feed Unit (including a paper
tray)
B B B B
Turn off the power, and then un-
plug the power cable.
C C C C
Hold the Paper Feed Unit as
shown in the illustration, and
then place it on a flat surface near
the place where the machine is to
be installed.
Note
❒ Be sure to work in a place with
enough space, so that you can
get behind the printer.
ZHBP310E
ZHBP300E