Ieee 1394 Configuration - Ricoh AP600N Setup Manual

Configuring the Printer for the Network

IEEE 1394 Configuration

Use this procedure to configure the
printer for use in the IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items are in-
cluded in the "Host Interface" menu.
Setting Name
3
DHCP
IP Address1394
Subnet Mask1394
IP over 1394
SCSI print
Bidi-SCSI print
*1
If DHCP is in use, IP address1394 and
Subnet Mask1394 are automatically
set.
Depending on the protocol you use,
procedures vary. See the following ta-
ble.
IP over 1394
SCSI print
A A A A
Press { { { { Menu} } } } .
On Line
Job Reset
Form Feed
Power
"Menu" appears on the panel dis-
play.
54
Value
On
*1
000.000.000.000
*1
000.000.000.000
Active
Active
Active
Steps A-J and then
go to steps O to P
Steps A-D and then
go to steps K to P
Menu
Escape
Enter
Error Data In
ZKGP020E
B B B B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Host
Interface" menu.
Menu:
Host Interface
C C C C
Press { { { { Enter #} } } } .
Menu
On Line
Job Reset Escape
Form Feed Enter
Power Error
The following message appears on
the panel display.
Host Interface:
I/O Buffer
D D D D
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "IEEE
1394 Setup".
Host Interface:
IEEE 1394 Setup
E E E E
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
IEEE 1394 Setup:
DHCP
Data In
ZKGP060E