Calibrate Ctrl - Printronix SL5000r User Manual

Chapter 3

CALIBRATE CTRL

CALIBRATE CTRL
CALIBRATE
CTRL
(from page 96)
Gap/Mark Auto
1
Sensor Calibrate
Disable* Run Calibrate
Mark
Gap
Advanced Gap
Advanced Notch
Paper Out Manual
1
Sensor Calibrate
Run Calibrate
Reflective*
Transmissive
Gap Length Cal in Peel
Mode
0.12 inches* Disable*
0.05 to 1.00 inches Enable
Notes:
* = Factory Default
Italicized items are available only when you enable Admin User (in the PRINTER CONTROL menu).
1
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown below:
Table 6
When you select an
Paper Out Sensor
option in Gap/Mark
defaults to...
Sensor...
Disable Reflective
Mark Reflective
Gap Reflective
Advanced Gap Transmissive
Advanced Notch Transmissive
If you change the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
2
When Admin User is enabled (in the PRINTER CONTROL menu), you can change the unit value to millimeters:
Under the Units submenu (in the MEDIA CONTROL menu), enable the "In Millimeters" option.
3
When Gap/Mark Sensor = Disable, Gap, or Mark, the default is 12. When Gap/Mark Sensor = Advanced Gap or
Advanced Notch, the default is 20.
138
Media Sensed
Profile Distance
2
Print Profile
0.00 inches
Pwr Up Head
Auto-Cal
Auto-Cal
Disable* Disable*
Enable
Enable
Min Calib Use Label
Delta Length
3
012* Enable*
012 to 050 Disable
Gap/Mark Paper Out
Thresh Thresh
171* 180*
000 to 255 000 to 255
Online Gap
Auto-Cal Windowing
Disable* Disable*
Enable Enable
Threshold Dynamic
Range
Sensing
50%* Disable*
5% to 95% Enable