Printronix SL5000r User Manual page 288

Chapter 4
Downloading Software If Flash Contains Only Boot Or Corrupt Code
14. Enter the following command:
filename.exe -pb<Enter>
where filename .exe is the file name you noted in step 10. This command
takes the file on the hard drive and copies it as a binary file into the flash
memory on the printer controller board.
15. After the software successfully downloads into flash memory, the printer
will reset itself.
16. If you have an external NIC:
a. Set the printer power switch to O (Off).
b. Connect the external NIC to the parallel port.
c. Connect the ethernet cable to the NIC.
d. Starting at step 4, page 284, repeat the "Downloading Software
288
Through The NIC Using FTP" procedure. (In other words, use the
two-key method to download software again.) This ensures that all
necessary code downloads into printer memory.