Printronix SL5000r User Manual page 341

Table 17. LCD Message Troubleshooting (continued)
Displayed Message
PWR SUPPLY HOT
See Manual
RBN TAKEUP FULL
Remove Used Rbn
REACTIVATING
HOST SERIAL
RECHARGE
BATTERY
Can User
Explanation
Correct?
Yes Power supply is hot.
Yes The ribbon takeup
spool is full.
Yes Normal message that
displays when you set
Validator Funct. =
Disable in the
VALIDATOR menu or
Battery Monitor =
Disable in the
BATTERY CONTROL
menu.
Yes This is the Time To Go
Alert you can set
(factory default = 1.0
Hour). This fault
detection is only
supported when the
ICP (Intelligent Control
Panel) option is
connected to the
printer serial port and
Battery Monitor =
Enable in the
BATTERY CONTROL
menu.
Fault Messages
Solution
1. Determine that the fan is
operating and that all air
vents are unobstructed.
2. Move the printer to a
cooler area.
3. If the problem persists,
contact your authorized
customer service
representative.
1. Empty the takeup spool.
2. If the takeup spool is not
full, try re-threading the
ribbon.
3. Disable Rbn Takeup Full in
the MEDIA CONTROL
menu.
No action required.
1. Plug the power cart cable
into an AC receptacle to
recharge the battery.
2. If recharging the battery
fails to clear the fault,
replace the battery or
batteries.
341