Printronix SL5000r User Manual page 232

Chapter 3
Emulation Submenus
Translation Tbl (SPC Twinax)
Prints out a table of the twinax interface's current character set. This operation
is valid only when the twinax interface is selected.
Translation Tbl (TN5250, Twinax)
Prints out a table of the twinax interface's current character set. This operation
is valid only when the twinax interface is the current interface.
True Vert 1/10
•
Disable (the default). When disabled and in High Resolution, a vertical
line's length in one inch and 1/10 inch increments is interpreted as 70/72
inch and 7/72 inch respectively.
•
Enable. When enabled, a vertical line's length is interpreted exactly,
which is 72/72 inch in one inch increments.
Trunc Dyn Data
This submenu allows the user to truncate the dynamic data up to the
maximum data length specified in Create Mode.
•
Disable (the default). If the dynamic data exceeds the maximum data
length, an error will report.
•
Enable. If the dynamic data exceeds the maximum data length, the data
truncates.
Truncate Alpha
•
Enable (the default). Prevents the printing of Error 48 (Element Off Page
Error) if alphanumeric data, including spaces, extends beyond the right
side of the form.
•
Disable.
Twinax Type
This parameter defines the printer emulation as follows:
•
IPDS 256 Bytes (the default)
•
IPDS 1024 Bytes
•
5225
•
4234
After the emulation has been changed, a POR status is sent to the host.
232