Printronix SL5000r User Manual page 212

Chapter 3
Emulation Submenus
Form Length (mm)
Form length is the number of lines that can be printed on a label. You can set
forms length in millimeters.
The factory default is shown in Table 3 on page 122.
Form Width (char.)
The forms width can be specified as a function of the current CPI (characters
per inch). The forms width set should not exceed the actual paper width.
The factory default is the maximum printing width divided by the selected
number of characters per inch.
Form Width (in.)
In this submenu, form width is specified in inches. The form width set should
not exceed the actual paper width.
The factory default is the maximum printing width.
Form Width (mm.)
In this submenu, form width is specified in millimeters. The form width set
should not exceed the actual paper width.
The factory default is the maximum printing width.
Forms Handling
This submenu allows the user to handle the form in the following ways:
•
Disable (the default). No effect.
•
Auto Eject. Automatically ejects a page at the end of the job to spill out
the last page.
•
Auto TOF. Automatically does a form feed (FF) at the end of each form to
the next top of form.
Format Control
Enables the printer to reflect the same spacing as CTPC model printers after
absolute and relative move commands are executed.
•
Disable (the default). Reflects distance, generated by the VGL feature,
PGL feature, and Hex Transparent control code sequence, in the new
position (after horizontal and vertical tabs are executed).
•
Enable. Does not reflect distance, generated by the VGL feature, PGL
feature, and Hex Transparent control code sequence, in the new position
(after horizontal and vertical tabs are executed).
212