4.3.2 cable lock (optional)
If a cable lock is installed, it should be removed before servicing the unit. To remove the cable
lock, unlock it and pull it out of the cable lock slot as shown in the following illustration.
4.3.3 hood cover
Before accessing the internal components of the hp workstation xw4100, the hood cover must be
removed. To remove the panel, follow these instructions.
Å
WARNING: Before removing the workstation hood cover, ensure that the workstation is turned off and
that the power cord is disconnected from the electrical outlet.
1. Remove power from the system.
2. Lay the unit in the desktop position as shown in the following illustration.
3. If necessary, unlock the panel.
4. Pull up and out on the cover latch 1 and at the same time slide the cover 2 away from the
bezel and then lift up.
To replace the hood cover, slide the cover back on until it snaps into place.
hp workstation xw4100 service and technical reference guide
removal and replacement procedures
4–9