C Sata Devices; Sata Guidelines - HP xw4100 Service And Technical Reference Manual

SATA guidelines

These systems support a mixed configuration of UATA/IDE, SCSI, and SATA hard drives.
NOTE:
Review the following diagram and table to determine the correct drive configuration for your
system.
When installing and operating SATA devices, you must follow these guidelines:
Use the SATA data cables with the 90 degree connector (326965-001) for the hard drive
bays. The 90 degree connector goes to the hard drive.
Use the longest data cable with the straight connectors (326965-002) if installing a hard drive
in an optical bay.
Connect the 4-2 pin LED cable (225537-001, included with SATA RAID controller kit) from
the RAID card header "JP1" (4 pin header) to the system board header labeled "SCSI LED"
(2 pin header).
Ä
CAUTION: Do not route data cables near the air intake to the power supply. Cables routed in this
manner may block the airflow and cause the workstation to overheat.
hp workstation xw4100 service and technical reference guide
SATA Devices
C
C–1