Test Error Codes - HP xw4100 Service And Technical Reference Manual

system diagnostics and troubleshooting

test error codes

error code
XXXX-02
XXXX-03
XXXX-05
XXXX-06
XXXX-07
XXXX-08
XXXX-09
XXXX-10
XXXX-11
XXXX-12
XXXX-13
XXXX-14
XXXX-15
XXXX-16
XXXX-17
XXXX-18
XXXX-21
65XX-24
66XX-24
67XX-24
XXXX-25
XXXX-30
XXXX-31
XXXX-32
XXXX-33
XXXX-34
5–18
description
Drive not installed.
Media not in drive.
Seek failure.
Drive timed out.
Drive busy.
Drive already reserved.
Unknown.
Unknown.
Media soft error.
Drive not ready.
Media error.
Drive hardware error.
Illegal drive command.
Media was changed.
Tape write-protected.
No data detected.
Drive command aborted.
Media hard error.
Media hard error.
Media hard error.
Unknown.
Controller timed out.
Unrecoverable error.
Controller/drive
disconnected.
Illegal controller command.
Invalid SCSI bus phase.
hp workstation xw4100 service and technical reference guide
recommended action
Check cable connections.
Check for and install data CD or
write-enabled tape in drive.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
1. Disable write-protect on tape cartridge.
2. Replace tape drive.
Replace the indicated device.
Replace the indicated device.
1. Back up data and perform Surface
Analysis to reallocate defect.
2. Replace drive.
1. Replace current data CD with different
data CD.
2. Replace drive.
1. Ensure correct media type for this tape
drive.
2. Replace current tape with new tape.
3. Replace tape drive.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.