Solving Memory Problems - HP xw4100 Service And Technical Reference Manual

system diagnostics and troubleshooting
solving network problems (continued)
problem
New network card will
not boot.
Cannot connect to
network server when
attempting Remote
System Installation.
System setup utility
reports unprogrammed
EEPROM.

5.6.12 solving memory problems

Ä
CAUTION: For those systems that support ECC memory, HP does not support mixing ECC and non-ECC
memory. Otherwise, the system will not boot the operating system.
solving memory problems
problem
System will not boot or
does not function properly
after installing additional
memory modules.
Out of memory error.
Memory count during POST
is wrong.
Insufficient memory error
during operation.
5–38
cause
New network card may be
defective or may not meet
industry-standard
specifications.
The network controller is
not configured properly.
Unprogrammed EEPROM.
cause
Memory module is not
the correct type or
speed or the new
memory module is not
seated properly.
Memory configuration
may not be set up
correctly.
You have run out of
memory to run the
application.
The memory modules
may not be installed
correctly.
Too many Terminate
and Stay Resident
programs (TSRs) are
installed.
You have run out of
memory for the
application.
hp workstation xw4100 service and technical reference guide
solution
Install a working, industry-standard
NIC, or change the boot sequence to
boot from another source.
Verify Network Connectivity, that a
DHCP Server is present, and that the
Remote System Installation Server
contains the NIC drivers for your NIC.
Flash the ROM.
solution
Replace module with the correct
industry-standard device for the
workstation.
On some models, ECC and non-ECC
memory modules cannot be mixed.
Use the Device Manager to check
memory configuration.
Check the application documentation
to determine the memory requirements.
Check that the memory modules have
been installed correctly and that
proper modules are used.
Delete any TSRs that you do not need.
Check the memory requirements for
the application or add more memory
to the workstation.