HP xw4100 Service And Technical Reference Manual page 97

error code
XXXX-35
XXXX-36
XXXX-39
XXXX-40
XXXX-41
XXXX-42
XXXX-43
XXXX-44
XXXX-50
XXXX-51
XXXX-52
XXXX-53
XXXX-54
XXXX-60
XXXX-61
XXXX-65
XXXX-90
XXXX-91
XXXX-99
hp workstation xw4100 service and technical reference guide
description
Invalid SCSI bus phase.
Invalid SCSI bus phase.
Error status from drive.
Target timed out.
SCSI bus stayed busy.
ACK/REQ lines bad.
ACK did not deassert.
Parity error.
Data pins bad.
Data line 7 bad.
MSG, C/D, and/or I/O
lines bad.
BSY never went busy.
BSY stayed busy.
Controller CONFIG-1
register bad
Controller CONFIG-2
register bad
Media not unloaded.
Fain failure.
Over temperature.
Autoloader reported tapes
not loaded properly.
system diagnostics and troubleshooting
recommended action
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
1. Ensure fan(s) connected.
2. Replace nonfunctional fan(s).
1. Ensure proper air flow.
2. Perform required maintenance and
cleaning.
1. Install tape(s) in autoloader tape drive
according to test instructions.
2. Change autoloader magazine.
5–19