Front Bezel; Bezel Blanks - HP xw4100 Service And Technical Reference Manual

removal and replacement procedures

4.3.4 front bezel

Follow these steps to remove the bezel:
1. With the power disconnected and the hood cover removed, lift up on the two tabs 1 located
on the front bezel.
2. Rotate the front bezel 2 away from the chassis as shown in the following illustration and
remove the bezel.

4.3.5 bezel blanks

To remove the bezel blanks do the follow:
1. After removing the front bezel, gently pull the subpanel 1, with the bezel blanks secured in
it, away from the front bezel.
2. Remove the desired bezel blank 2 by pulling the blank away from the subpanel.
The bezel blanks are keyed to assist you in replacing the blanks.
NOTE:
4–10 hp workstation xw4100 service and technical reference guide