3Com E4500-24 Cli Configuration Manual page 749

Figure 1-4 Send file dialog box
Step 8: Click <Send>. The system displays the page, as shown in
Figure 1-5 Sending file page
Step 9: After the sending process completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Step 10: Reset HyperTerminal's baudrate to 9600 bps (refer to Step 4 and 5). Then, press any key as
prompted. The system will display the following information when it completes the loading.
Bootrom updating.....................................done!
If the HyperTerminal's baudrate is not reset to 9600 bps, the system prompts "Your baudrate
should be set to 9600 bps again! Press enter key when ready".
You need not reset the HyperTerminal's baudrate and can skip the last step if you have chosen
9600 bps. In this case, the system upgrades the Boot ROM automatically and prompts "Bootrom
updating now.....................................done!".
Figure
1-6
1-5.