3Com E4500-24 Cli Configuration Manual page 369

Creating a RADIUS Scheme
Configuring RADIUS Authentication/Authorization Servers
Configuring RADIUS Accounting Servers
Configuring Shared Keys for RADIUS Messages
Configuring the Maximum Number of RADIUS Request
Transmission Attempts
Configuring the
Configuring the Type of RADIUS Servers to be Supported
RADIUS client
Configuring the Status of RADIUS Servers
Configuring the Attributes of Data to be Sent to RADIUS
Servers
Configuring Timers for RADIUS Servers
Enabling Sending Trap Message when a RADIUS Server
Goes Down
Enabling the User Re-Authentication at Restart Function
Configuring the
Refer to the configuration of the RADIUS Server.
RADIUS server
Complete the following tasks to configure RADIUS (the switch functions as a local RADIUS server):
Configuring the RADIUS
server
Configuring the RADIUS
client
The RADIUS service configuration is performed on a RADIUS scheme basis. In an actual network
environment, you can either use a single RADIUS server or two RADIUS servers (primary and
secondary servers with the same configuration but different IP addresses) in a RADIUS scheme. After
Task
Task
Creating a RADIUS Scheme
Configuring RADIUS Authentication/Authorization
Servers
Configuring RADIUS Accounting Servers
Configuring Shared Keys for RADIUS Messages
Configuring the Maximum Number of RADIUS
Request Transmission Attempts
Configuring the Type of RADIUS Servers to be
Supported
Configuring the Status of RADIUS Servers
Configuring the Attributes of Data to be Sent to
RADIUS Servers
Configuring the Local RADIUS Server
Configuring Timers for RADIUS Servers
Enabling Sending Trap Message when a RADIUS
Server Goes Down
Refer to the configuration of the RADIUS client
2-10
Remarks
Required
Required
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
—
Remarks
Required
Required
Required
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
—