Remote Loading Using Tftp - 3Com E4500-24 Cli Configuration Manual

Figure 1-13 Upload file switch.btm to the switch
Step 8: Configure switch.btm to be the Boot ROM at next startup, and then restart the switch.
<Sysname> boot bootrom switch.btm
This will update Bootrom on unit 1.
Upgrading Bootrom, please wait...
Upgrade Bootrom succeeded!
<Sysname> reboot
After the switch restarts, the file switch.btm is used as the Boot ROM. It indicates that the Boot ROM
loading is finished.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except that the file to be
downloaded is the host software file, and that you need to use the boot boot-loader command to select
the host software used for the next startup of the switch.
The steps listed above are performed in the Windows operating system, if you use other FTP client
software, refer to the corresponding user guide before operation.
Only the configuration steps concerning loading are listed here. For detailed description on the
corresponding configuration commands, refer to FTP-SFTP-TFTP part of this manual.

Remote Loading Using TFTP

The remote loading using TFTP is similar to that using FTP. The only difference is that TFTP is used to
load software to the switch, and the switch can only act as a TFTP client.
Continue? [Y/N] y
1-15