Enabling The Vlan-Vpn Feature For A Port; Configuring The Tpid Value For Vlan-Vpn Packets On A Port - 3Com E4500-24 Cli Configuration Manual

Enabling the VLAN-VPN Feature for a Port

Configuring the TPID Value for VLAN-VPN
Packets on a Port
Configuring the Inner-to-Outer Tag Priority
Replicating and Mapping Feature
As XRN fabric is mutually exclusive with VLAN-VPN, make sure that XRN fabric is disabled on the
switch before performing any of the configurations listed in the above table. For information about XRN
fabric, refer to XRN Fabric Configuration in this manual.
Enabling the VLAN-VPN Feature for a Port
Follow these steps to enable the VLAN-VPN feature for a port:
To do...
Enter system view
Enter Ethernet port view
Enable the VLAN-VPN feature
on the port

Configuring the TPID Value for VLAN-VPN Packets on a Port

For your device to correctly identify the VLAN tagged frames from the public network, make sure that
the TPID you will use is the same as that used on the peer device in the public network.
Follow these steps to configure the TPID for VLAN-VPN packets on a port:
To do...
Enter system view
Enter Ethernet port view
Set the TPID value on the port
Task
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn enable
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn tpid value
Required
Optional
Optional
—
—
Required
By default, the VLAN-VPN
feature is disabled on a port.
—
—
Required
Do not set the TPID value to
any of the protocol type values
listed in
For 3Com series switches, the
TPID defaults to 0x8100.
1-4
Remarks
Remarks
Remarks
Table 1-1.