To do...
Configure line rate
Configuration example
Configure line rate for outbound packets on Ethernet 1/0/1.
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] line-rate outbound 1024
Configuring VLAN Mapping
Refer to section
Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL module of this
manual for information about defining ACL rules.
The ports on which the configuration is to be performed have been determined.
The VLAN ID to be set for the packets has been determined.
Configuration procedure
Follow these steps to configure VLAN mapping:
To do...
Enter system view
Enter Ethernet port view
Configure VLAN mapping
Configuring Queue Scheduling
Refer to section
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters have been determined.
Use the command...
line-rate { inbound |
outbound } target-rate
[ burst-bucket
burst-bucket-size ]
VLAN Mapping
for information about VLAN mapping.
Use the command...
system-view
interface interface-type
interface-number
traffic-remark-vlanid inbound
acl-rule remark-vlan remark-vlanid
Queue Scheduling
for information about queue scheduling.
Required
Specify a committed information
rate (CIR) for the target-rate
argument, and specify a
committed bust size (CBS) for the
burst-bucket-size argument.
By default, line rate is disabled.
—
—
Required
By default, VLAN mapping is
not configured.
1-19
Remarks
Remarks