Vlan Mapping Configuration Example - 3Com E4500-24 Cli Configuration Manual

[Sysname-Ethernet1/0/2] traffic-priority inbound ip-group 3000 rule 1 local-precedence 3
[Sysname-Ethernet1/0/2] traffic-priority inbound ip-group 3000 rule 2 local-precedence 2
[Sysname-Ethernet1/0/2] quit
3) Configure queue scheduling
# Apply SP queue scheduling algorithm.
[Sysname] queue-scheduler strict-priority

VLAN Mapping Configuration Example

Network requirements
Two customer networks are connected to the public network through Switch A and Switch B. Configure
the VLAN mapping function on the switches to enable the hosts on the two customer networks to
communicate through public network VLANs.
Switch A provides network access for terminal devices in VLAN 100 and VLAN 200 through
Ethernet 1/0/11 and Ethernet 1/0/12. On the other side of the public network, Switch B provides
network access for servers in VLAN 100 and VLAN 200 through Ethernet 1/0/15 and Ethernet
1/0/16.
Switch A provides access to the public network through Ethernet 1/0/10 and Switch B provides
access to the public network through Ethernet 1/0/17.
Configure the switches to have packets of VLAN 100 and packets of VLAN 200 transmitted in VLAN 500
and VLAN 600 across the public network.
Network diagram
Figure 1-11 Network diagram for VLAN mapping configuration
Eth1/0/10
Eth1/0/11
SwitchA
VLAN100
VLAN100
SwitchB
Eth1/0/15
Eth1/0/17
Public Network
VLAN500/600
Eth1/0/12
VLAN200
VLAN200
Eth1/0/16
1-26