Controlling Network Management Users By Source Ip Addresses; Prerequisites - 3Com E4500-24 Cli Configuration Manual

Network diagram
Figure 8-1 Network diagram for controlling Telnet users using ACLs
10.110.100.46
Host A
IP network
Host B
10.110.100.52
Configuration procedure
# Define a basic ACL.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule 1 permit source 10.110.100.52 0
[Sysname-acl-basic-2000] quit
# Apply the ACL.
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] acl 2000 inbound

Controlling Network Management Users by Source IP Addresses

You can manage an Ethernet switch through network management software. Network management
users can access switches through SNMP.
You need to perform the following two operations to control network management users by source IP
addresses.
Defining an ACL
Applying the ACL to control users accessing the switch through SNMP

Prerequisites

The controlling policy against network management users is determined, including the source IP
addresses to be controlled and the controlling actions (permitting or denying).
Controlling Network Management Users by Source IP Addresses
Controlling network management users by source IP addresses is achieved by applying basic ACLs,
which are numbered from 2000 to 2999.
Follow these steps to control network management users by source IP addresses:
To do...
Enter system view
Switch
Use the command...
system-view
8-4
Remarks
—