Port Isolation Configuration Example; Displaying And Maintaining Port Isolation Configuration - 3Com E4500-24 Cli Configuration Manual

When a member port of an aggregation group joins/leaves an isolation group, the other ports in the
same aggregation group will join/leave the isolation group at the same time.
For ports that belong to an aggregation group and an isolation group simultaneously, removing a
port from the aggregation group has no effect on the other ports. That is, the rest ports remain in
the aggregation group and the isolation group.
Ports that belong to an aggregation group and an isolation group simultaneously are still isolated
even when you remove the aggregation group in system view.
Adding an isolated port to an aggregation group causes all the ports in the aggregation group on
the local unit to be added to the isolation group.
Switch 4500 series switches support cross-device port isolation if XRN fabric is enabled.
For Switch 4500 series switches belonging to the same XRN Fabric, the port isolation configuration
performed on a port of a cross-device aggregation group cannot be synchronized to the other ports
of the aggregation group if the ports reside on other units. That is, to add multiple ports in a
cross-device aggregation group to the same isolation group, you need to perform the configuration
for each of the ports individually.

Displaying and Maintaining Port Isolation Configuration

To do ...
Display information about the
Ethernet ports added to the
isolation group

Port Isolation Configuration Example

Network requirements
Figure 1-1
As shown in
and Ethernet1/0/4 respectively. The switch connects to the Internet through Ethernet1/0/1.
It is desired to isolate PC2, PC3 and PC4 to disable them from communicating directly with each other.
Use the command ...
display isolate port
, PC2, PC3 and PC4 connect to the switch ports Ethernet1/0/2, Ethernet1/0/3,
1-2
Remarks
Available in any view