Setting Up - Canon imageCLASS MF266dn II User Manual

Setting Up

This is a list of problems that can occur during setup of the machine. Check how to troubleshoot the problem based on
the symptom.
◼
Problems During Driver Installation
The Machine Connected via WSD Port Is Not Displayed During Driver Installation(P. 590)
◼
Problems with Wireless LAN and Wired LAN Connection
Cannot Connect to Wireless LAN
Check whether the machine can connect to the network.
Cannot Connect to Wireless LAN(P. 591)
Cannot Connect to Wired LAN
The IP address setting may have failed. Set the IP address again.
Setting IPv4 Addresses(P. 75)
Setting IPv6 Addresses(P. 79)
Cannot Connect to Wireless LAN and Wired LAN at the Same Time
You cannot connect the machine to a wireless LAN and wired LAN at the same time. You can connect to USB
and wireless LAN or USB and wired LAN at the same time.
◼
Problems with USB Connection
The Computer Cannot Communicate with the Machine
Try the following:
● Replace the USB cable. If the USB cable is long, replace it with a short cable.
● If you are using a USB hub, connect the machine directly to the computer using a USB cable.
Troubleshooting
589
8Y8C-0E0