Ip Igmp Snooping Vlan Static - Cisco WS-C3560E-24PD-E Command Reference Manual

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands

ip igmp snooping vlan static

Use the ip igmp snooping static global configuration command to enable Internet Group Management
Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast group. Use
the no form of this command to remove ports specified as members of a static multicast group.
Syntax Description
vlan-id
ip-address
interface interface-id
Defaults By default, there are no ports statically configured as members of a multicast group.
Command Modes Global configuration
Command History Release
12.1(19)EA1
Usage Guidelines
VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The configuration is saved in NVRAM.
Examples
This example shows how to statically configure a host on an interface:
Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface gigabitethernet0/1
Configuring port gigabitethernet0/1 on group 0100.5e02.0203
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
78-16405-05
ip igmp snooping vlan vlan-id static ip-address interface interface-id
no ip igmp snooping vlan vlan-id static ip-address interface interface-id
Enable IGMP snooping on the specified VLAN. The range is 1 to 1001
and 1006 to 4094.
Add a Layer 2 port as a member of a multicast group with the specified group
IP address.
Specify the interface of the member port. The keywords have these
meanings:
•
•
•
Modification
This command was introduced.
fastethernet interface number—a Fast Ethernet IEEE 802.3 interface.
gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3z
interface.
port-channel interface number—a channel interface. The range is 0
to 48.
ip igmp snooping vlan static
Catalyst 3560 Switch Command Reference
2-173