Cisco WS-C3560E-24PD-E Command Reference Manual page 141

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
Usage Guidelines
A cause (all, dhcp-rate-limit, and so forth) is the reason why the error-disabled state occurred. When a
cause is detected on an interface, the interface is placed in an error-disabled state, an operational state
that is similar to a link-down state.
If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration
command for the cause, the interface is brought out of the error-disabled state and allowed to retry the
operation when all causes have timed out. If you do not set a recovery mechanism, you must enter the
shutdown and then the no shutdown commands to manually recover an interface from the
error-disabled state.
Examples This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Switch(config)# errdisable detect cause link-flap
You can verify your setting by entering the show errdisable detect privileged EXEC command.
Related Commands Command
show errdisable detect
show interfaces
78-16405-05
Description
Displays error-disabled detection information.
status err-disabled Displays interface status or a list of interfaces in the
error-disabled state.
errdisable detect cause
Catalyst 3560 Switch Command Reference
2-109