Ip Igmp Max-Groups - Cisco WS-C3560E-24PD-E Command Reference Manual

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands

ip igmp max-groups

Use the ip igmp max-groups interface configuration command to set the maximum number of Internet
Group Management Protocol (IGMP) groups that a Layer 2 interface can join or to configure the IGMP
throttling action when the maximum number of entries is in the forwarding table. Use the no form of this
command to set the maximum back to the default, which is to have no maximum limit, or to return to the
default throttling action, which is to drop the report.
Syntax Description number
action deny
action
replace
Defaults
The default maximum number of groups is no limit.
After the switch learns the maximum number of IGMP group entries on an interface, the default
throttling action is to drop the next IGMP report that the interface receives and to not add an entry for
the IGMP group to the interface.
Command Modes Interface configuration
Command History Release
12.1(19)EA1
78-16405-05
ip igmp max-groups {number | action {deny | replace}}
no ip igmp max-groups {number | action}
The maximum number of IGMP groups that an interface can join. The range is 0 to
4294967294. The default is no limit.
When the maximum number of entries is in the IGMP snooping forwarding table, drop
the next IGMP join report. This is the default action.
When the maximum number of entries is in the IGMP snooping forwarding table,
replace the existing group with the new group for which the IGMP report was received.
Modification
This command was introduced.
Catalyst 3560 Switch Command Reference
ip igmp max-groups
2-155