Cisco WS-C3560E-24PD-E Command Reference Manual page 368

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
service-policy
Classification using a port trust state (for example, mls qos trust [cos | dscp | ip-precedence] and a
policy map (for example, service-policy input policy-map-name) are mutually exclusive. The last one
configured overwrites the previous configuration.
Examples This example shows how to apply plcmap1 to an physical ingress port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy input plcmap1
This example shows how to remove plcmap2 from a physical port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no service-policy input plcmap2
This example shows how to apply plcmap1 to an ingress SVI when VLAN-based QoS is enabled:
Switch(config)# interface vlan 10
Switch(config-if)# service-policy input plcmap1
Catalyst 3560 Switch Command Reference
2-336
78-16405-05