Dot1X Default - Cisco WS-C3560E-24PD-E Command Reference Manual

dot1x default

dot1x default
Use the dot1x default interface configuration command to reset the IEEE 802.1x parameters to their
default values.
Syntax Description This command has no arguments or keywords.
Defaults
These are the default values:
•
•
•
•
•
•
•
•
•
Command Modes Interface configuration
Command History Release
12.1(19)EA1
Examples This example shows how to reset the IEEE 802.1x parameters on a port:
Switch(config-if)# dot1x default
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command
show dot1x
Catalyst 3560 Switch Command Reference
2-90
dot1x default
The per-port IEEE 802.1x protocol enable state is disabled (force-authorized).
The number of seconds between re-authentication attempts is 3600 seconds.
The periodic re-authentication is disabled.
The quiet period is 60 seconds.
The retransmission time is 30 seconds.
The maximum retransmission number is 2 times.
The host mode is single host.
The client timeout period is 30 seconds.
The authentication server timeout period is 30 seconds.
Modification
This command was introduced.
[interface interface-id]
Chapter 2
Description
Displays IEEE 802.1x status for the specified port.
Catalyst 3560 Switch Cisco IOS Commands
78-16405-05