Cisco WS-C3560E-24PD-E Command Reference Manual page 436

show interfaces
This is an example of output from the show interfaces capabilities command for an interface.
Switch# show interfaces gigabitethernet0/2 capabilities
GigabitEthernet0/2
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Trunk mode:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Fast Start:
QoS scheduling:
CoS rewrite:
ToS rewrite:
UDLD:
Inline power:
SPAN:
PortSecure:
Dot1x:
This is an example of output from the show interfaces interface description command when the
interface has been described as Connects to Marketing by using the description interface configuration
command.
Switch# show interfaces gigabitethernet0/2 description
Interface Status
Gi0/2
This is an example of output from the show interfaces etherchannel command when port channels are
configured on the switch:
Switch# show interfaces etherchannel
----
Port-channel1:
Age of the Port-channel
Logical slot/port
GC
Port state
Port-channel2:
Age of the Port-channel
Logical slot/port
GC
Port state
Port-channel3:
Age of the Port-channel
Logical slot/port
GC
Port state
Catalyst 3560 Switch Command Reference
2-404
WS-C3560-24PS
10/100/1000BaseTX
10,100,1000,auto
full,auto
802.1Q,ISL
on,off,desirable,nonegotiate
yes
rx-(off,on,desired),tx-(none)
yes
rx-(not configurable on per port basis),tx-(4q2t)
yes
yes
yes
no
source/destination
yes
yes
Protocol Description
up down
= 03d:20h:17m:29s
= 10/1
= 0x00000000
= Port-channel Ag-Not-Inuse
= 03d:20h:17m:29s
= 10/2
= 0x00000000
= Port-channel Ag-Not-Inuse
= 03d:20h:17m:29s
= 10/3
= 0x00000000
= Port-channel Ag-Not-Inuse
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
Connects to Marketing
Number of ports = 0
HotStandBy port = null
Number of ports = 0
HotStandBy port = null
Number of ports = 0
HotStandBy port = null
78-16405-05