Show Ipv6 Access-List - Cisco WS-C3560E-24PD-E Command Reference Manual

show ipv6 access-list

show ipv6 access-list
Use the show ipv6 access-list user EXEC command to display the contents of all current IPv6 access
lists.
This command is available only if the switch is running the advanced IP services image and you have
Note
configured a dual IPv4 and IPv6 Switch Database Management (SDM) template on the switch.
Syntax Description access-list-name
Command Modes User EXEC
Command History Release
12.2(25)SED
Usage Guidelines
The show ipv6 access-list command provides output similar to the show ip access-list command, except
that it is IPv6-specific.
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
Examples The following output from the show ipv6 access-list command shows IPv6 access lists named inbound
and outbound:
Router# show ipv6 access-list
IPv6 access list inbound
Table 2-26
Table 2-26 show ipv6 access-list Field Descriptions
Field
IPv6 access list inbound
permit
tcp
any
Catalyst 3560 Switch Command Reference
2-440
show ipv6 access-list [access-list-name]
Modification
This command was introduced.
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
describes the significant fields shown in the display.
Description
Name of the IPv6 access list, for example, inbound.
Permits any packet that matches the specified protocol type.
Transmission Control Protocol. The higher-level (Layer 4) protocol type
that the packet must match.
Equal to ::/0.
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
(Optional) Name of access list.
78-16405-05