Cisco WS-C3560E-24PD-E Command Reference Manual page 417

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
This is an example of output from the show dot1x statistics interface interface-id command.
describes the fields in the display.
Switch# show dot1x statistics interface gigabitethernet0/1
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 15
RxStart = 4
RxInvalid = 0
RxVersion = 1
Table 2-22
Field
TxReqId
TxReq
TxTotal
RxStart
RxLogoff
RxRespId
RxResp
RxInvalid
RxLenError
RxTotal
RxVersion
LastRxSrcMac
Related Commands Command
dot1x default
78-16405-05
AuthFail-Vlan = 1001
AuthFail-Max-Attempts = 3
Critical Port = Enabled
TxReq = 0
RxLogoff = 0
RxLenErr = 0
LastRxSrcMac 00d0.b71b.35de
show dot1x statistics Field Descriptions
Description
Number of Extensible Authentication Protocol (EAP)-request/identity frames
that have been sent.
Number of EAP-request frames (other than request/identity frames) that have
been sent.
Number of Extensible Authentication Protocol over LAN (EAPOL) frames of any
type that have been sent.
Number of valid EAPOL-start frames that have been received.
Number of EAPOL-logoff frames that have been received.
Number of EAP-response/identity frames that have been received.
Number of valid EAP-response frames (other than response/identity frames) that
have been received.
Number of EAPOL frames that have been received and have an unrecognized
frame type.
Number of EAPOL frames that have been received in which the packet body
length field is invalid.
Number of valid EAPOL frames of any type that have been received.
Number of received packets in the IEEE 802.1x Version 1 format.
Source MAC address carried in the most recently received EAPOL frame.
Description
Resets the IEEE 802.1x parameters to their default values.
TxTotal = 15
RxRespId = 1 RxResp = 1
RxTotal= 6
Catalyst 3560 Switch Command Reference
show dot1x
Table 2-22
2-385