Match (Class-Map Configuration) - Cisco WS-C3560E-24PD-E Command Reference Manual

match (class-map configuration)

match (class-map configuration)
Use the match class-map configuration command to define the match criteria to classify traffic. Use the
no form of this command to remove the match criteria.
Syntax Description access-group
acl-index-or-name
input-interface
interface-id-list
ip dscp dscp-list
ip precedence
ip-precedence-list
Defaults No match criteria are defined.
Command Modes Class-map configuration
Command History Release
12.1(19)EA1
12.2(25)SE
Usage Guidelines
The match command is used to specify which fields in the incoming packets are examined to classify
the packets. Only the IP access group or the MAC access group matching to the Ether Type/Len are
supported.
To define packet classification on a physical-port basis, only one match command per class map is
supported. In this situation, the match-all and match-any keywords are equivalent.
Catalyst 3560 Switch Command Reference
2-234
match {access-group acl-index-or-name | input-interface interface-id-list | ip dscp dscp-list | ip
precedence ip-precedence-list}
no match {access-group acl-index-or-name | input-interface interface-id-list | ip dscp dscp-list |
ip precedence ip-precedence-list}
Number or name of an IP standard or extended access control list (ACL) or
MAC ACL. For an IP standard ACL, the ACL index range is 1 to 99 and 1300
to 1999. For an IP extended ACL, the ACL index range is 100 to 199
and 2000 to 2699.
Specify the physical ports to which the interface-level class map in a
hierarchical policy map applies. You can specify up to six entries in the list
by specifying a port (counts as one entry), a list of ports separated by a space
(each port counts as an entry), or a range of ports separated by a hyphen
(counts as two entries).
List of up to eight IP Differentiated Services Code Point (DSCP) values to
match against incoming packets. Separate each value with a space. The range
is 0 to 63. You also can enter a mnemonic name for a commonly-used value.
List of up to eight IP-precedence values to match against incoming packets.
Separate each value with a space. The range is 0 to 7. You also can enter a
mnemonic name for a commonly-used value
Modification
This command was introduced.
The input-interface interface-id-list keyword was added.
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
78-16405-05