Test Cable-Diagnostics Tdr - Cisco WS-C3560E-24PD-E Command Reference Manual

Chapter 2 Catalyst 3560 Switch Cisco IOS Commands

test cable-diagnostics tdr

Use the test cable-diagnostics tdr privileged EXEC command to run the Time Domain Reflector (TDR)
feature on an interface.
Syntax Description interface-id
Defaults
There is no default.
Command Modes Privileged EXEC
Command History Release
12.2(25)SE
Usage Guidelines TDR is supported only on 10/100/1000 copper Ethernet ports. It is not supported on 10/100 ports or on
SFP module ports. For more information about TDR, see the software configuration guide for this
release.
After you run TDR by using the test cable-diagnostics tdr interface interface-id command, use the
show cable-diagnostics tdr interface interface-id privileged EXEC command to display the results.
Examples This example shows how to run TDR on an interface:
Switch# test cable-diagnostics tdr interface gigabitethernet0/2
TDR test started on interface Gi0/2
A TDR test can take a few seconds to run on an interface
Use 'show cable-diagnostics tdr' to read the TDR results.
If you enter the test cable-diagnostics tdr interface interface-id command on an interface that has a
link status of up and a speed of 10 or 100 Mbps, these messages appear:
Switch# test cable-diagnostics tdr interface gigabitethernet0/3
TDR test on Gi0/9 will affect link state and traffic
TDR test started on interface Gi0/3
A TDR test can take a few seconds to run on an interface
Use 'show cable-diagnostics tdr' to read the TDR results.
Related Commands Command
show cable-diagnostics tdr
78-16405-05
test cable-diagnostics tdr interface interface-id
Specify the interface on which to run TDR.
Modification
This command was introduced.
Description
Displays the TDR results.
Catalyst 3560 Switch Command Reference
test cable-diagnostics tdr
2-655