Setting The Port Priority Level; Setting The Port Speed - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Configuring Ethernet and Fast Ethernet Ports
Console> (enable) set port name 1/2 Server Link
Port 1/2 name set.
Console> (enable) show port 1
Port
----- ------------------ ---------- ---------- ------ ------ ----- ------------
1/1
1/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Tue Jun 16 1998, 16:25:57
Console> (enable)

Setting the Port Priority Level

You can configure the priority level of each port. When ports request access to the switching bus
simultaneously, the switch uses port priority level to determine the order in which to give ports access.
To set the port priority level, perform this task in privileged mode:
Task
Step 1 Configure the priority level for a port.
Step 2
Verify that port priority level is configured correctly. show port [mod_num[/port_num]]
This example shows how to set the port priority level to high for port 1/1 and verify that the port priority
is configured correctly:
Console> (enable) set port level 1/1 high
Port 1/1 level set to high.
Console> (enable) show port 1
Port
----- ------------------ ---------- ---------- ------ ------ ----- ------------
1/1
1/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Tue Jun 16 1998, 16:25:57
Console> (enable)

Setting the Port Speed

You can configure the port speed on 10/100-Mbps Fast Ethernet modules. Use the auto keyword to have
the port autonegotiate speed and duplex mode with the neighboring port.
Make sure the device on the other end of the link is also configured for autonegotiation or a port speed
Caution
or duplex mismatch will result.
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
4-4
Name Status
Router Connection connected
Server Link connected
Name Status
Router Connection connected
Server Link connected
Chapter 4 Configuring Ethernet and Fast Ethernet Switching
Vlan Level Duplex Speed Type
trunk normal half
trunk normal half
Command
set port level mod_num/port_num
{normal | high}
Vlan Level Duplex Speed Type
trunk high half
trunk normal half
100 100BaseTX
100 100BaseTX
100 100BaseTX
100 100BaseTX
78-12647-02