Configuring The Switch For Local Authentication And Authorization - Cisco 3032 Software Configuration Manual

Configuring the Switch for Local Authentication and Authorization

To set up a Kerberos-authenticated server-client system, follow these steps:
•
•
For instructions, see the "Kerberos Configuration Task List" section in the "Security Server Protocols"
chapter of the Cisco IOS Security Configuration Guide, Release 12.2, at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter0918
6a00800ca7ad.html
Configuring the Switch for Local Authentication and
Authorization
You can configure AAA to operate without a server by setting the switch to implement AAA in local
mode. The switch then handles authentication and authorization. No accounting is available in this
configuration.
Beginning in privileged EXEC mode, follow these steps to configure the switch for local AAA:
Command
Step 1
configure terminal
Step 2
aaa new-model
Step 3 aaa authentication login default local
Step 4 aaa authorization exec local
Step 5 aaa authorization network local
Step 6 username name [privilege level]
{password encryption-type password}
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
7-44
Configure the KDC by using Kerberos commands.
Configure the switch to use the Kerberos protocol.
Purpose
Enter global configuration mode.
Enable AAA.
Set the login authentication to use the local username database. The
default keyword applies the local user database authentication to all
ports.
Configure user AAA authorization, check the local database, and allow
the user to run an EXEC shell.
Configure user AAA authorization for all network-related service
requests.
Enter the local database, and establish a username-based authentication
system.
Repeat this command for each user.
For name, specify the user ID as one word. Spaces and quotation
•
marks are not allowed.
(Optional) For level, specify the privilege level the user has after
•
gaining access. The range is 0 to 15. Level 15 gives privileged EXEC
mode access. Level 0 gives user EXEC mode access.
• For encryption-type, enter 0 to specify that an unencrypted password
follows. Enter 7 to specify that a hidden password follows.
• For password, specify the password the user must enter to gain access
to the switch. The password must be from 1 to 25 characters, can
contain embedded spaces, and must be the last option specified in the
username command.
Chapter 7 Configuring Switch-Based Authentication
OL-12247-04