Configuring Cisco Ios/Pix Radius Settings For A User Group - Cisco 2509 - Router - EN User Manual

Configuration-specific User Group Settings
Step 7

Configuring Cisco IOS/PIX RADIUS Settings for a User Group

Note
User Guide for Cisco Secure ACS for Windows Server
6-38
Configuring Cisco VPN 5000 Concentrator RADIUS Settings for a User
•
Group, page 6-43
Configuring Microsoft RADIUS Settings for a User Group, page 6-45
•
Configuring Nortel RADIUS Settings for a User Group, page 6-46
•
Configuring Juniper RADIUS Settings for a User Group, page 6-48
•
• Configuring BBSM RADIUS Settings for a User Group, page 6-49
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
The Cisco IOS/PIX RADIUS parameters appear only when both the following are
true:
A AAA client has been configured to use RADIUS (Cisco IOS/PIX) in
•
Network Configuration.
Group-level RADIUS (Cisco IOS/PIX) attributes have been enabled in
•
Interface Configuration: RADIUS (Cisco IOS/PIX).
Cisco IOS/PIX RADIUS represents only the Cisco VSAs. You must configure
both the IETF RADIUS and Cisco IOS/PIX RADIUS attributes.
To hide or display Cisco IOS/PIX RADIUS attributes, see
Configuration Options for Non-IETF RADIUS Attributes, page
applied as an authorization to a particular group persists, even when you remove
or replace the associated AAA client; however, if you have no AAA clients of this
(vendor) type configured, the VSA settings do not appear in the group
configuration interface.
Chapter 6 Setting Up and Managing User Groups
Setting Protocol
78-14696-01, Version 3.1
3-16. A VSA