Cisco 2509 - Router - EN User Manual page 120

AAA Client Configuration
For Cisco Secure ACS to provide AAA services to a AAA client, you must ensure
that gateway devices between AAA clients and Cisco Secure ACS allow
communication over the ports needed to support the applicable AAA protocol
(RADIUS or TACACS+). For information about ports used by AAA protocols,
see
To add a AAA client, follow these steps:
In the navigation bar, click Network Configuration.
Step 1
Result: The Network Configuration page opens.
Do one of the following:
Step 2
•
•
Result: The Add AAA Client page appears.
In the AAA Client Hostname box, type the name assigned to this AAA client (up
Step 3
to 32 characters).
In the AAA Client IP Address box, type the AAA client IP address or addresses.
Step 4
In the Key box, type the shared secret that the AAA client and Cisco Secure ACS
Step 5
use to encrypt the data (up to 32 characters).
Note
If you are using NDGs, from the Network Device Group list, select the name of
Step 6
the NDG to which this AAA client should belong, or select Not Assigned to set
this AAA client to be independent of NDGs.
Note
User Guide for Cisco Secure ACS for Windows Server
4-16
AAA Protocols—TACACS+ and RADIUS, page
If you are using NDGs, click the name of the NDG to which the AAA client
is to be assigned. Then, click Add Entry below the AAA Clients table.
To add a AAA client when you have not enabled NDGs, click Add Entry
below the AAA Clients table.
For correct operation, the identical key must be configured on the AAA
client and Cisco Secure ACS. Keys are case sensitive.
To enable NDGs, click Interface Configuration, click Advanced
Options, and then select the Network Device Groups check box.
Chapter 4 Setting Up and Managing Network Configuration
1-6.
78-14696-01, Version 3.1