Cisco 2509 - Router - EN User Manual page 118

AAA Client Configuration
User Guide for Cisco Secure ACS for Windows Server
4-14
If all authentication requests from a particular Cisco Aironet Access
Note
Point are PEAP or EAP-TLS requests, use RADIUS (IETF) instead
of RADIUS (Cisco Aironet). Cisco Secure ACS cannot support
PEAP authentication using the RADIUS (Cisco Aironet) protocol.
RADIUS (Cisco BBMS)—RADIUS using Cisco BBMS VSAs. Select
–
this option if the network device is a Cisco BBMS network device
supporting authentication via RADIUS.
RADIUS (Cisco IOS/PIX)—RADIUS using Cisco IOS/PIX VSAs. This
–
option enables you to pack commands sent to a Cisco IOS AAA client.
The commands are defined in the Group Setup section. Select this option
for RADIUS environments in which key TACACS+ functions are
required to support Cisco IOS equipment.
RADIUS (Cisco VPN 3000)—RADIUS using Cisco VPN 3000 VSAs.
–
Select this option if the network device is a Cisco VPN 3000 series
Concentrator.
– RADIUS (Cisco VPN 5000)—RADIUS using Cisco VPN 5000 VSAs.
Select this option if the network device is a Cisco VPN 5000 series
Concentrator.
RADIUS (IETF)—IETF-standard RADIUS, using no VSAs. Select this
–
option if the AAA client represents RADIUS-enabled devices from more
than one manufacturer and you want to use standard IETF RADIUS
attributes. If the AAA client represents a Cisco Aironet Access Point
used only by users authenticating with PEAP or EAP-TLS, this is also the
protocol to select.
RADIUS (Ascend)—RADIUS using Ascend RADIUS VSAs. Select this
–
option if the network device is an Ascend network device supporting
authentication via RADIUS.
– RADIUS (Juniper)—RADIUS using Juniper RADIUS VSAs. Select
this option if the network device is a Juniper network device supporting
authentication via RADIUS.
Chapter 4 Setting Up and Managing Network Configuration
78-14696-01, Version 3.1