Qualified Personnel - Danfoss iC2-Micro Series Design Manual

Design Guide | iC2-Micro Frequency Converters
HOT SURFACES
The drive contains metal components that are still hot even after the drive has been powered off. Failure to
observe the high-temperature symbol (yellow triangle) on the drive can result in serious burns.
Be aware that internal components, such as busbars, may be extremely hot even after the drive has been
l
powered off.
Do not touch exterior areas that are marked by the high-temperature symbol (yellow triangle). These
l
areas are hot while the drive is in use and immediately after being powered off.

Qualified Personnel

1.8
To allow trouble-free and safe operation of the unit, only qualified personnel with proven skills are allowed to transport, store, assemble,
install, program, commission, maintain, and decommission this equipment.
Persons with proven skills:
Are qualified electrical engineers or persons who have received training from qualified electrical engineers and are suitably
l
experienced to operate devices, systems, plants, and machinery in accordance with pertinent laws and regulations.
Are familiar with the basic regulations concerning health and safety/accident prevention.
l
Have read and understood the safety guidelines given in all guides provided with the unit, especially the instructions given in the
l
operating guide of the drive.
Have good knowledge of the generic and specialist standards applicable to the specific application.
l
12 | Danfoss A/S © 2024.08
CAUTION
Introduction and Safety
AJ402315027937en-000401 / 130R1239