D-Link NetDefend DFL-CP310 User Manual page 97

In this field...
MAC Cloning
H ardware MAC
Addre ss
Cloned MAC
Address
High Availability
Do not connect if
this gateway is in
passive state
Dead Connection
Detection
Chapter 4: Configuring the Internet Connection
Do this...
A MAC address is a 12-digit identifier assigned to every network device. If
your ISP restricts connections to specific, recognized MAC addresses, you
must select this option to clone a MAC address.
Note: When configuring MAC cloning for the secondary Internet
conn ection, the DMZ/WAN2 port must be configured as WAN2; otherwise
this field is disabled. For information on configuring ports, see Managing
Ports on page 145.
This field displays the NetDefend firewall's MAC address.
This field is read-only .
Do one of the following:
•
Click This Computer to automa
your computer to the NetDefe
•
If the ISP requires authentica
different computer, type the MAC addr
Note: In the secondary Internet connection, this field is enabled only if the
DMZ/WAN2 port is set to WAN2.
The High Availability area only appears in NetDefend with Power Pack.
If you are using High Availability (HA), select this option to specify that the
gateway should connect to the Internet only if it is the Active Gateway in
the HA cluster.
This field is only enabled if HA is configured.
For information on HA, see Configuring High Availability on page 119.
tically "clone" the MAC address of
nd firewall.
tion using the MAC address of a
ess in this field.
Using Internet Setup
81