D-Link NetDefend DFL-CP310 User Manual page 352

Adding and Editing VPN Sites
Tabl e 66: VPN G ateway Address Fields
In this field... Do this...
Gateway Address Type the IP address of the Site-to-Site VPN Gateway to which you want
to connect, as given to you by the network administrator.
Bypass NAT Select this option to allow the VPN site to bypass NAT when connecting
to your internal network.
This option is selected by default.
Bypass the Select this option to allow the VPN site to bypass the firewall and access
firewall your internal network without restriction.
T able 67: Route Based VPN Fields
In this field... Do this...
T unnel Local IP Type a local IP address for this end of the VPN tunnel.
Tunnel Remote IP Type the IP address of the remote end of the VPN tunnel.
O SPF Cost Type the cost of this link for dynamic routing purposes.
The default value is 10.
If OSPF is not enabled, this setting is not used. OSPF is enabled using
the NetDefend command line interface (CLI). For information on using
CLI, see Controlling the Appliance via the Command Line on page
386. For information on the relevant commands for OSPF, refer to the
NetDefend CLI Reference Guide.
336 D-Link NetDefend firewall User Guide